UPMAX CRANES (SUZHOU) CO., LTD

Professional manufacturer with high quality,competitive price&fast shipment.

Home > Knowledge > Content
Note the following five points about the wire rope electric hoist:
- Jun 22, 2018 -

1. When the wire rope electric hoist reaches the address of the equipment, it shall carefully check whether there is any damage or other conditions during the transportation.

Habit 2. In order to use different h beam orbit, when the equipment to the gasket to adjust the operation organization of the width of the wheelset, adjust should adhere to the wheel rim and h beam under the flank face with C = 4 ~ 5 mm per side clearance.

3. Stop pin and elastic buffer devices shall be installed at both ends of wire rope electric hoist rails to prevent the hoist from derailment or collision and damage to the body.

4. For use of ground wires on i-beam or its connected structural beam, nude copper wires of less than 4~5mm or metal conductors with a section not less than 25mm2 can be used.

5. Electrical equipment after the completion of all equipment, all electric circuit control circuit to ground insulation resistance should not be less than 1000 Ω per v working voltage.